How to Identify Bearing Models —— XSY Bearing

A bearing reference is not just a number. It contains a lot of information about the bearing.

Composition of bearing references

First, something about the complete bearing reference. It usually consists of numbers, sometimes combined with letters. The so-called prefixes and suffixes indicate additional properties of the bearing.

Complete bearing number with prefix and suffix.

Part 1: The bearing type

The basic indications consist of three fixed components. The first part is a number, a letter, or a combination of these. This is the description of the bearing type.

The most common bearing types.

The 6203-C3 bearing begins with “6” and is therefore a single-row groove ball bearing. And the 7416 is a single-row angular contact ball bearing because it begins with “7”. The first number gives a quick indication of the bearing type.

Part 2: The size series

Now we come to the second part of the basic designation. This is the “size series”. The first number of this section, which is sometimes omitted, indicates the width (for radial bearings) or height (for axial bearings). The second number of the size series refers to the outside diameter.

Size Series

The higher the value, the wider the inner and outer rings. Often the ball size will also increase. Bearings with higher values can be subjected to heavier loads.

In our first example of 6203-C3, the size series is “2”. The table shows this is an average width class. And in our second example of 7416, the size series is “4”. Which means it can withstand a (relatively) heavier load.

Part 3: The inner diameter

Finally, the third part of the basic designation. This refers to the inside diameter, also called the bore. These are the last 2 digits in the basic designation. A simple formula will calculate the inside diameter.

This part of the basic designation refers to the bore.

Is the number 04 or greater? Then multiply this number by five to get the inside diameter (in mm). Very simple. But there is (of course) an exception. If the number is less than 04, the inner diameter is as shown below:

Inside diameter codes

Back to our examples. For 6203-C3, “03” indicates the inside diameter. The table above shows it is 17 mm. For 7416, “16” indicates the inside diameter. A quick calculation (16 x 5) shows the inside diameter of this bearing to be 80 mm. It’s as simple as that.